Rubyfish: Difference between revisions
(dev dock link) |
(→Developer Dock: Add pictures) |
||
| Line 57: | Line 57: | ||
Mind to first solder pogo pins to the usb cable | Mind to first solder pogo pins to the usb cable | ||
[[File:Rover-dock-pogo.jpg|none|thumb]] | |||
Then use a 1.5mm drill bit to widen the channels in the 3D Print and insert the pogo pin assembly. | |||
[[File:Rover-rubyfish-dock.jpg|none|thumb]] | |||
Revision as of 18:10, 26 February 2026
Description
This watch is sold in several variations:
| Model Number | Model Name | Codename |
|---|---|---|
| WH12018 | TicWatch Pro | rubyfish |
| WH12018 | TicWatch Pro 3 Ultra GPS | rubyfish |
| WH11013 | TicWatch Pro 3 Cellular/LTE | rover |
| WH11013 | TicWatch Pro 3 Ultra | rover |
Although there are variations in the physical size and appearance of these watches, all models use the same rubyfish AsteroidOS image.
Developer Dock
You will need to build a dock to access the USB pads since the stock cable does not connect to the inner D+ / D- data pads. This one has been developed by the community and test working multiple times now:
https://www.printables.com/model/634749-ticwatch-pro-3-developer-usb-data-dock-using-pogo
Mind to first solder pogo pins to the usb cable
Then use a 1.5mm drill bit to widen the channels in the 3D Print and insert the pogo pin assembly.
