Tetra: Difference between revisions
m (fix filename) |
(Added information under "Manually getting to fastboot" on tetra's wiki page AND added information under "Issues") |
||
| Line 38: | Line 38: | ||
== Issues == | == Issues == | ||
Tetra suffers from graphical glitches due to the unique Broadcom SoC - the graphics subsystem on this watch is different from the more common Qualcomm watches supported by AsteroidOS, so they are difficult to diagnose and fix. This makes the | Tetra suffers from graphical glitches due to the unique Broadcom SoC - the graphics subsystem on this watch is different from the more common Qualcomm watches supported by AsteroidOS, so they are difficult to diagnose and fix. This is what makes the build unstable and makes it only usable for a general overview of the OS and not a daily driver. | ||
= Repair = | = Repair = | ||
| Line 45: | Line 45: | ||
= Miscellaneous hardware docs = | = Miscellaneous hardware docs = | ||
== Manually getting to fastboot == | == Manually getting to fastboot == | ||
Tetra has a special menu to get into fastboot mode without a computer. This can be accessed by holding down the power button for 6-10 seconds on startup. You will then see an "Insert USB" screen. Double press the side button when this appears, and do not insert a USB cable yet. Then, double press the side button again to enter fastboot. Pushing the side button once will show various options for factory reset, normal boot, or recovery mode. Double press if you wish to enter any of these other options too. | |||
Revision as of 11:08, 13 March 2024
Tetra (Sony Smartwatch 3) is a rectangular watch with a transflective LCD display and sports-oriented features. Unfortunatley, it suffers from graphical glitches due to the unique Broadcom CPU. Warning: The Sony Smartwatch 3 is the only watch supported by AsteroidOS using a Broadcom SoC. Its support is known for being experimental. It presents various limitations for a daily usage but is enough to get an overall overview of AsteroidOS.
Description
Tetra is a rectangular watch with a lot of sensors including GPS and NFC. The display is a transflective LCD, which is readable in nearly all lighting conditions and can stay on to provide a very power-efficient always-on display. Uniquely, it charges through an integrated USB micro-B connector (covered by a rubber flap), so there is no dock. The smartwatch 'module' sits inside of a combined strap/frame assembly - straps are available in silicone and metal bracelet styles, and you can even 3D print a replacement case.
Issues
Tetra suffers from graphical glitches due to the unique Broadcom SoC - the graphics subsystem on this watch is different from the more common Qualcomm watches supported by AsteroidOS, so they are difficult to diagnose and fix. This is what makes the build unstable and makes it only usable for a general overview of the OS and not a daily driver.
Repair
Opening does not compromise any glue seal so should not compromise water resistance. To open the watch, remove it from the strap, then undo the four screws around the display and pry up on the back metal casing. The display should come off in its frame - beware of the flex cable connecting it to the motherboard. Parts are not generally available. You will likely need to replace the battery when buying these watches as they are getting quite old.
Miscellaneous hardware docs
Manually getting to fastboot
Tetra has a special menu to get into fastboot mode without a computer. This can be accessed by holding down the power button for 6-10 seconds on startup. You will then see an "Insert USB" screen. Double press the side button when this appears, and do not insert a USB cable yet. Then, double press the side button again to enter fastboot. Pushing the side button once will show various options for factory reset, normal boot, or recovery mode. Double press if you wish to enter any of these other options too.