GW4: Difference between revisions
mNo edit summary |
No edit summary |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 14: | Line 14: | ||
| SoC || Exynos W920 dual core 1.18 GHz; GPU: Mali-G68 | | SoC || Exynos W920 dual core 1.18 GHz; GPU: Mali-G68 | ||
|- | |- | ||
| Sensors || * Heart rate monitor | | Sensors || | ||
* Heart rate monitor | |||
* Bioelectrical Impedance Analysis | * Bioelectrical Impedance Analysis | ||
* Accelerometer | * Accelerometer | ||
* Gyroscope | * Gyroscope | ||
* Barometer | * Barometer | ||
|- | |||
| Battery || Non-removable 247mAh / 361mAh | |||
|} | |} | ||
=== Miscellaneous hardware docs === | |||
==== Manually getting into Download or Recovery Mode ==== | |||
Press and hold both buttons until the "Rebooting..." screen appears. Release both buttons and press the power button (red outline) 3 times. | |||
The reboot menu should be displayed. Press the power button to cycle between the options and confirm the selection with a long press (3 seconds). | |||
==== Skipping initial setup ==== | |||
The pairing and setup of the watch can be skipped by pressing and holding down the Wear OS logo on the pairing screen. | |||
==== Debugging and Jigs ==== | |||
The device probably exposes a UART via the USB pads if ID is connected to GND with a 619k resistor, similar to the [[WC1]]. This is currently untested. | |||
Latest revision as of 12:14, 21 December 2023
The Samsung Galaxy Watch 4 (LTE) is a round smartwatch that is one of the first ones to contain a bioelectrical impedance analysis (BIA) sensor.
| Model number | SM-R860, SM-R870, SM-R880, SM-R890 (Wi-Fi only), SM-R865U, SM-R875U, SM-R885U, SM-R895U (USA, LTE model), SM-R895F (Int., LTE model) |
| Memory | 1.5 GB |
| Storage | 16 GB |
| SoC | Exynos W920 dual core 1.18 GHz; GPU: Mali-G68 |
| Sensors |
|
| Battery | Non-removable 247mAh / 361mAh |
Miscellaneous hardware docs
Manually getting into Download or Recovery Mode
Press and hold both buttons until the "Rebooting..." screen appears. Release both buttons and press the power button (red outline) 3 times.
The reboot menu should be displayed. Press the power button to cycle between the options and confirm the selection with a long press (3 seconds).
Skipping initial setup
The pairing and setup of the watch can be skipped by pressing and holding down the Wear OS logo on the pairing screen.
Debugging and Jigs
The device probably exposes a UART via the USB pads if ID is connected to GND with a 619k resistor, similar to the WC1. This is currently untested.